The Challenges to Swim Spa Covers

Swim Spas represent distinct difficulties when it comes to covering them.
We can all concur that the swim spa needs to be covered when not in use for all the same factors a hot tub needs a cover. The difficulty is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot more difficult.
Getting a brand-new swim spa is an amazing occasion in life. You’re anticipating the workout you’ll obtain from using it. Maybe you’re a little relieved to have actually finally made a selection from the different models you took a look at. At any rate, you probably weren’t believing much about the cover you would use.
Normally, the cover that gets back with your brand-new purchase will be a four section rigid foam filled cover that will divide in the center and go off both ends.
No big deal.
Till it starts to get heavy.
Which it constantly does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a design flaw. Built in obsolescence since as soon as it is positioned in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are very small as they increase from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.
It occurs slowly and on a Swim Spa Cover which is made from specific areas, at varying speeds. So eventually you’ll observe one or two of the sections are truly getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance since you still need to raise that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com created a different design for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately end up in some land fill, they created one that uses air chambers that do not suck up moisture.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or break down at the joints either. So if you own a swim spa, and you mean to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to order today, bookmark this site so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *