The Challenges to Swim Spa Covers

Swim Spas represent distinct obstacles when it pertains to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same factors a hot tub requires a cover. The challenge is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot harder.
Getting a new swim spa is an interesting event in life. You’re anticipating the workout you’ll receive from using it. Possibly you’re a little relieved to have finally made a selection from the various models you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Usually, the cover that gets home with your new purchase will be a four section stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style defect. Built in obsolescence due to the fact that as quickly as it is put in use over the warm water in your swim spa it is inevitable.
It’s not from rain, so having a taper won’t make any difference. In fact you might have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are extremely little as they increase from the water surface area. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and becomes caught in the cover.

It occurs gradually and on a Swim Spa Cover which is made of specific areas, at differing speeds. So ultimately you’ll observe one or two of the areas are actually getting heavy. The bar lifters on completions of the swim spa aren’t much assistance because you still have to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com developed a new style for their Swim Spa Covers
Instead of using several foam panels to construct Swim Spa Covers that will ultimately wind up in some garbage dump, they created one that utilizes air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or break down at the seams either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the Swim Spa Cover for it.
If you’re not all set to buy today, bookmark this site so you can find it once again when you’re prepared!

Leave a Reply

Your email address will not be published. Required fields are marked *