Getting The Best Swim Spa Cover

Swim Spas represent special challenges when it comes to covering them.
We can all agree that the swim spa needs to be covered when not in use for all the same factors a hot tub requires a cover. The obstacle is that because of the length of the swim spa and the height of the sides, removing and replacing the cover can be a lot harder.
Getting a new swim spa is an exciting event in life. You’re eagerly anticipating the workout you’ll get from using it. Possibly you’re a little relieved to have actually lastly made a selection from the various designs you looked at. At any rate, you most likely weren’t thinking much about the cover you would use.
Generally, the cover that gets back with your brand-new purchase will be a four section rigid foam filled cover that will split in the center and go off both ends.
No big deal.
Until it begins to get heavy.
Which it constantly does.
Every stiff foam filled Swim Spa Cover ever made winds up the same way and it is not the fault of the user. It’s a design defect. Integrated in obsolescence since as soon as it is placed in use over the warm water in your swim spa it is inescapable.
It’s not from rain, so having a taper will not make any distinction. In fact you might have it under a roof and the cover will still get heavy.
The reason is the steam from the water. The particles of steam are extremely little as they increase from the water surface. They make their way into the little cracks and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It happens gradually and on a Swim Spa Cover which is made of individual areas, at varying speeds. So ultimately you’ll observe a couple of of the sections are actually getting heavy. The bar lifters on completions of the swim spa aren’t much assistance due to the fact that you still have to raise that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different design for their Swim Spa Covers
Instead of using numerous foam panels to develop Swim Spa Covers that will ultimately end up in some garbage dump, they created one that utilizes air chambers that do not suck up wetness.
In fact SpaCap.com Swim Spa Covers are light-weight, insulate much better, will not blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine fabric, these covers won’t fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the cover for it.
If you’re not all set to buy today, bookmark this website so you can find it once again when you’re all set!

Leave a Reply

Your email address will not be published. Required fields are marked *